Above Ground Deep Well Jet Pump Installation

Submersible deep well pump installation domestic water system.

Above ground deep well jet pump installation.

Typical deep well jet pump installation a captive air jet pumps usually come with a 30 50 pressure switch factory installed on the pump. To be clear about how your 2 line jet pump is working to deliver water to the building in the building or somewhere above ground a 2 line jet pump includes an impeller that pushes water down the smaller diameter well pipe and near the bottom of that pipe in the well water is pushed through a jet or venturi an opening shaped like a funnel. Great pump and easy to install. With the pipe and pump on the ground beside the well wrap the threads of the 1 1 4 inch male barbed adapter with thread tape and thread it into the top of the pump.

Above ground jet pumps have an output capacity of 1 to 70 gpm and range from to 1 hp for residential use. Both pump types sit above the ground. Material choices are cast iron stainless steel or thermoplastic. But some models can offer way more than that.

The shallow well jet pumps draw water from one line situated in wells no deeper than a maximum of 25. Wiring plumbing suction foot inlet priming the pump. Step 2 before installing a shallow well or centrifu gal pump make sure the total suction lift does not exceed 25 feet. A convertible jet pump for deep wells up to 90 costs 400 to 1 200.

It s connected to the intake end of the jet housing and extends down into the well. Jet pump installation manual shallow well jet pumps step 1 make sure the well is pumped clean and that sand and grit are absent. It is an effective way to get water out of wells especially those between 25 and 50 feet deep. That means they don t push water out of the pump but suck it up.

Complete set and installation. In contrast with submersible models the jet pump is located above the ground. Step 2 slide two hose clamps over the fitting. A shallow well jet pump costs 300 to 900 to replace and supports wells 25 or less.

Jet pumps come in two options shallow well or deep well. If replacing the switch we recommend using one with a 30 5 psi setting. For wells deeper than 80 a submersible pump system is recommended.