Above Ground Pool Pump Stopped Working

Turn the air relief valve on the pool filter clockwise to relieve any existing pressure the pressure reading on the pool filter gauge should be zero.

Above ground pool pump stopped working.

On the electrical side problems can occur with the electric motor timeclock breaker or wires. When a pump doesn t turn on or starts shutting off quickly after it s started it s usually an electrical problem which could mean loose connections a bad capacitor or overloaded voltage. All of these things are usually fairly simple fixes. If it is loose remove the lid and check the integrity of the o ring that seals the lid.

Barring problems with other pool equipment a pool pump problem will either be an electrical issue or a plumbing issue. You first have to start a troubleshooting process to determine where the problem with your above ground pool pump is. But it could also be a jammed motor. There are two primary parts to the pump.

This is the most common source of. Often what appears to be a pool pump problem is actually a filter problem or a valve problem so the first step is to rule out any mis aligned valves or obstructions in the filter or pipes. The first one is of course the motor and the second is what is called the wet end if the pump won t power up follow these steps. The sun is usually the biggest culprit when it comes to housing damage.

The good new is it s pretty straight forward just follow the steps below. Relieve any existing pressure by turning the air relief valve counter clockwise on your pool filter until the. Disconnect any power to the pump and move the diverter valve so that the main drain side is turned to off. Turn off the pump and check the tightness of the strainer lid on the pump.

Considered the hull of the pump a housing encases all of the above parts. A pool pump can be primed by following these fairly simple steps. Cut off the main drain by turning the diverter valve.